ProTek RC Servo Lead & Terminal Crimping Tool Trailing Arm (1) Full-range

(1) Full-range

Almost as soon as the firm’s 44/48HP 0-4-0 locomotives were making an appearance

using wagons that otherwise would have been converted from VSX to VLEX

this kit is a must-have addition to your assortment

ProTek RC Servo Lead & Terminal Crimping Tool Trailing Arm (1) Full-rangeThe ProTek RC Servo Lead & Terminal Crimping Tool is the tool you need to make custom length signal wires for your ESCs, receiver batteries and servos. This tool safely secures the connector pins on wire sizes between 14 and 28awg, without damaging the pin or the wire. Simply strip a short length of the shielding off the wires, install the connector pin into the tool, insert the wire into the pin, and squeeze the tool to crimp the pin in place. NOTE: